I have a task on a table which triggers a proces flow. It's a task that add's a record to the same table and the process flow refreshes and does a ‘go to row’ to make sure the newly created record is selected. This work, however if the table is displayed in a lookup, it doesn't. I don't know why? There is no concurrent proces flow active, so it should run?
Solved
Process flow in lookup not working
- Superhero
- 196 replies
Best answer by Mark Jongeling
We do support the following extended property:
AllowProcessFlowsInLookupDialogs
“By default, process flows cannot be executed in a lookup. With this property, a process flow is allowed access to a lookup, provided all process actions are allowed in a lookup.
Forbidden process actions are: Manual, Close document, Open document, Activate document, and Zoom in on detail.”
Values: Yes / No
Hope this property helps!
This topic has been closed for replies.
+23Hi René,
Short answer, Process flows do not get started from lookups.
+23We do support the following extended property:
AllowProcessFlowsInLookupDialogs
“By default, process flows cannot be executed in a lookup. With this property, a process flow is allowed access to a lookup, provided all process actions are allowed in a lookup.
Forbidden process actions are: Manual, Close document, Open document, Activate document, and Zoom in on detail.”
Values: Yes / No
Hope this property helps!
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.