Hi,
Would like to check is there a way to update the configuration in IAM when creating a user, when we're using a process flow?
Is there a settings that I can put to update the Configuration to any of the option below automatically?
Thanks
Solved
IAM - User Preference - auto setup of Configure
+1- Sidekick
Best answer by Jeroen van den Belt
Hi
If it's always the same value you want to use, you can set the default in IAM here: Advanced menu > group Master data > User preference availability.
Does this answer your question sufficiently?
This topic has been closed for comments
+9 Hi
If it's always the same value you want to use, you can set the default in IAM here: Advanced menu > group Master data > User preference availability.
Does this answer your question sufficiently?
+1- Sidekick
Hi
I have tried setting up the advance config to make Move a default option.
But it doesn't work when I create from my application. In IAM Yes, when I create manually, I can see that it is defaulted to Move, but that is not my intention.
Note that I have a task process to create a user, so this will create application user and also create user in IAM, it's part of the flow.
Thank you.
- Superhero
The column for that is “write_back_usr_pref_type_id”. In your case “Move”, so that means the value 3. (Be sure to check if that value 3 is the same in your case)
In case an older platform (< 2024): the column will be “write_back_up_type_id”.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.