One of our customers is using the ‘treeview component’ to browse their catalog. When selecting a category the corresponding products will be show.
At the moment it is possible to select multiple categories, yet the products shown are only of the first selected category.
Is it possible to disable the multiselect in the treeview? Or, even better, make it so that all the corresponding products are shown?
Solved
Is it possible to disable multiselect in the treeview?
- Rookie
Best answer by Anne Buit
With the upcoming release of the Software Factory - 2019.1 - you can configure an extender to prevent multi-selection for both trees and grids. At this point, no custom extender is needed.
This topic has been closed for replies.
Hi Don,
The question with regard to disabling multi-selection has already been answered here. The answer applies to the treeview component as well.
I'm afraid that showing the details of all selected products is not possible due to various technical reasons.
The question with regard to disabling multi-selection has already been answered here. The answer applies to the treeview component as well.
I'm afraid that showing the details of all selected products is not possible due to various technical reasons.
+5With the upcoming release of the Software Factory - 2019.1 - you can configure an extender to prevent multi-selection for both trees and grids. At this point, no custom extender is needed.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.