When running the smoke test, I notice that durations above 10,000 ms end with: 'The command did not complete - the command timed out'.
This is always an encouragement to critically review your code, but is there perhaps a way to adjust this time?
Kind regards
Best answer by Jeroen van den Belt
Hi
This timeout value of 10 seconds is currently set and provided by Thinkwise, and there is no supported way for you to change it.
I suggest creating an idea for this, so we can consider replacing this hardcoded value with a configurable setting.
+10Hi
This timeout value of 10 seconds is currently set and provided by Thinkwise, and there is no supported way for you to change it.
I suggest creating an idea for this, so we can consider replacing this hardcoded value with a configurable setting.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
