After entering a value in the filter form for a specific cube field, the cube does not seem to refresh. Pressing the refresh button on the action bar also results in no activity.
I can only get the cube to refresh when I swap to a different tab (chart in this case) and back to the pivotgrid.
What am I missing here?
Solved
Cube refresh after filtering?
Best answer by Jeroen van den Belt
Hi
This sounds like something that requires further investigation with more reproduction details. Could you provide these in a TCP ticket? I think that would be the best route to investigate this further. Once that’s submitted, I’ll close this question.
+10Hi
This sounds like something that requires further investigation with more reproduction details. Could you provide these in a TCP ticket? I think that would be the best route to investigate this further. Once that’s submitted, I’ll close this question.
Hi
It seems there are certain conditions that break the refresh of the cube. I am not sure yet what action is causing this. When I am able to figure out a reproductive method, I’ll create a TCP ticket for it. No need to keep the question open for it though.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.