At the moment, the only way translations could be added for a table variant is by setting Translate flag on in the Settings tab page of the variant:
It is easier and more intuitive to do that directly from the Translations tab page of the variant:
Page 1 / 1
Perhaps it would be even more intuitive if the Translation detail tab was not available until Translate is turned on. The Translate checkbox determines if a translation object should be generated and read by the GUI to show the alternative translation over the base object.
New→Open
Open→Working on it!
For the next release, we have implemented a solution where you can directly indicate whether a variant needs to be translated when creating it. If you specify that this is the case, the translation objects will be generated in the background immediately. These will then be visible when you navigate to the Translations tab. This will apply to variants for tables, tasks and reports.
Working on it!→Next release
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.