Hi,
I made a small change to a PROCEDURE template and when I tried to generate the code group on the Functionality > Assigning > gear icon I get the following error:
The control procedure it points to seems to be autogenerated?
Any pointers on what is going wrong here?
Best answer by Mark Jongeling
Hi,
A similar issue had been resolved by a Generation definition of the project it occurs on. Does that solve the issue?
Did you change anything in the control procedure itself besides just the template? (Code group , Assignment or Type perhaps?)
Or is there code present in the control procedure itself (this should only be possible on certain Types)
Did you change anything in the control procedure itself besides just the template? (Code group , Assignment or Type perhaps?)
Or is there code present in the control procedure itself (this should only be possible on certain Types)
The control procedure it points to “exh_interface_sp” seems to be automagically created by Thinkwise.
I only changed the contents of a procedure, the procedure I changed is not mentioned in the error
judging from the procedure's name, it's a part of the Exchange_365 base project, does your project generate at all?
The error you're seeing might not have anything to do with the template changes you made.
+23Hi,
A similar issue had been resolved by a Generation definition of the project it occurs on. Does that solve the issue?
Hi,
A similar issue had been resolved by a Generation definition of the project it occurs on. Does that solve the issue?
That worked like a charm...
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
